Bambu Loop Processor

Start extrusion for copies 2 to N. Nozzle already hot under residual pressure — use the value auto-read from the gcode. If over-extrusion occurs, reduce slightly.

Retraction before push-off at the end of each cycle. Standard printing 0.8mm is fine. In loop mode the nozzle stays hot during ejection and may leave stringing.
To limit stringing: 2.0–3.0 mm

Wait time in seconds between cooldown end and the next copy. During this pause, chamber fans run full to flush accumulated heat. Without a pause, chamber temperature rises across copies, degrading overhang and bridging quality on PLA.
30–60 seconds is usually sufficient.